Sub-Base Removal - Nordson ProBlue Flex Product Manual

Adhesive melter with bbconn controls

Hide thumbs Also See for ProBlue Flex:

Table of Contents

E 2020 Nordson Corporation

Sub-base Removal

1. Loosen the two M8 socket head cap screws on the front of the chassis

using an M6 hex wrench.

Figure F-11 Remove melter from the sub-base

2. Open the E-Box enclosure door and remove the side enclosure panel.

See figure on the left (E-Box enclosure door and side enclosure panel

highlighted in grey).

Opening the E-Box enclosure door and removing the side enclosure

panel allows access to the chassis, chassis cover plate, and

chassis-to-sub-base ground wire.

ProBlue Flex 400/480 Volt Transformer

Part 1128350_02