HEIDENHAIN iTNC 530 Service Manual page 640

MP Function and input
MP7683 Executing pallet tables and NC programs
Format:
Input:
Bit 1 - Program Run, Full Sequence mode
0: During the start, a complete NC program is run.
1: At the start all NC programs are executed up to next pallet.
Bit 2 – Program Run, Full Sequence mode
0: As defined in bit 1
1: All NC programs and pallets up to the end of the table are executed.
Bit 3 – When the end of the table is reached, the process begins again with the first line.
0: Function is not in effect
1: Function is effective (bit 2=1)
Bit 4 – Editing the active pallet table
0: Active pallet table cannot be edited.
1: The active pallet can be edited in the PROGRAM RUN, FULL SEQUENCE and
PROGRAM RUN, SINGLE BLOCK modes.
Bit 5 – AUTOSTART soft key
0: Do not display soft key
1: Display soft key
Bit 6 – Display of pallet table and NC program
0: Both simultaneously in a split screen
1: Pallet table or NC program individually
Bit 7 – AUTOSTART function
0: AUTOSTART function by NC
1: AUTOSTART function by PLC
Bit 8 – Procedure for tool-oriented machining in the Program Run operating modes
0: NC start machines all workpieces on the pallet until the next tool change
1: NC start executes all NC programs until the end of the pallet
MP7683 Executing pallet tables and NC programs
Bit 5 – EDIT PALLET soft key
0: EDIT PALLET soft key is not displayed
1: EDIT PALLET soft key is displayed
30 – 640
%xxxxxxxxx
Bit 0 – No function
HEIDENHAIN Service Manual iTNC 530
SW version
and
behavior
PLC
RUN
PLC
RUN
340 490-05