3-D Touch Probe - HEIDENHAIN iTNC 530 Service Manual

30.4.9 3-D touch probe

MP Function and input
MP6010 Selection of the touch probe
Input:
1: Touch probe with infrared transmission (TS 632)
2: Touch probe with infrared transmission (TS 440, TS 640)
3: TS 444 touch probe, battery free
MP6120 Probing feed rate (triggering touch probe)
Input:
MP6130 Maximum measuring range
Input:
MP6140 Setup clearance above measuring point
Input:
MP6150 Rapid traverse in probing cycle
Input:
MP6151 Pre-positioning in probing cycle with rapid traverse
Input:
1: Pre-positioning at rapid traverse
MP6160 M function for probing from opposite directions
Input:
0: Function inactive
1 to 999: Number of the M function for spindle orientation through PLC
MP6161 M function for orienting the touch probe before every measuring process
Input:
0: Function inactive
1 to 999: Number of the M function
MP6162 Orientation angle
Input:
MP6163 Minimum difference between the current spindle angle and MP6162 before executing
an oriented spindle stop
Input:
MP6165 Orient the probe before approaching with Cycle 0 or 1, or with manual probing
Input:
1: Probe is oriented and always deflected in the same direction
MP6166 Probing direction of the touch probe with consideration of an active basic rotation (only
manual measuring cycles)
Input:
1: Active
July 2010
0: Touch probe with cable transmission (TS 120, TS 220)
1 to 10 000 [mm/min]
0.001 to 99 999.9999 [mm]
0.001 to 99 999.9999 [mm]
10 to 20 000 [mm/min]
0: Pre-position with speed from MP6150
–1: Spindle orientation directly by NC
–1: Spindle orientation directly by the NC
0 to 359.9999 [°]
0 to 3.0000 [°]
0: Probe is not oriented before each probing
0: Inactive
SW version
and
behavior
PLC
CN123
340 490-04
PLC
RUN
CN123
340 490-05
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
340 490-02
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
30 – 611