HEIDENHAIN iTNC 530 Service Manual page 577

After you have modified parameter values for service purposes:
Activate the
modified values
Missing or incorrect entries result in error messages from the control that prompt you to correct
your entry.
The following errors are displayed:
Input error
0
1
2
3
4
6
If the control does not recognize any errors, it automatically exits the machine parameter editor
and is ready for operation after a defined reaction.
If parameter values were changed and confirmed with END, the control can react as follows:
Reaction to change
If the machine manufacturer agrees that the machine should be operated with the new
Operating the
settings...
machine with the
new values
July 2010
Place the cursor after the last modified parameter in the next line. -->
The MP list is structured completely.
Exit the machine parameter list by pressing the END key.
Meaning
No MP number found
Invalid MP number
No separator (:) found
Entry value incorrect
MP defined twice
MP cannot be stored
Caution
Most machine parameters cannot be stored while an NC program is running.
The error message Parallel operation not possible appears.
The program must be stopped and exited. Then the modified data can be saved.
Modified values are immediately confirmed without reset and new referencing (e.g., when
changing color settings).
Axes must be referenced anew (e.g., when changing axis parameters).
A reset is started (e.g., when changing certain control-loop parameters).
Note
This behavior is defined by HEIDENHAIN and cannot be influenced!
If you have reason to doubt that a changed parameter was transferred or not, the control can
be rebooted manually.
Transmit the changed parameter values in the original MP list (or activate an agreed MP list),
write your name (or owner's name) and modification date as a comment into the header of the
list.
Create a new backup of the machine data. --> See "Backup on an External Data Medium"
on page 13 – 192.
30 – 577