Reading In And Out Of Individual Files Or Directories - HEIDENHAIN iTNC 530 Service Manual

13.3 Reading In and Out of Individual Files or Directories

There are several possibilities of reading in and downloading files and directories:
Connection setup
Transferring data to
the USB flash drive
13 – 186
Connection of a USB device; transfer using the dual-window concept in
the program management
Transfer using TNCremoNT
Transfer using TNCserver
Note
Information on setting data interfaces and reading in and out of data (e.g., TNCserver
operation) can be found in the User's Manual for the iTNC 530.
Connect a USB stick --> See "Connection Setup" on page 13 – 172
or ...
Establish the connection between the control and the laptop using TNCremoNT.
--> See "Connection Setup" on page 13 – 172.
Caution
Use the dual-window concept also on the iTNC 530 processor control with Windows
when transferring control data to a USB stick. Only then the required BINARY-to-ASCII data
conversion is ensured.
Note
To change to the PLC partition you must have entered the PLC code number before.
Note
The following description uses the program manager with the setting Enhanced 1 --> See
"Setting the Program Manager" on page 12 – 162.
Switch to the Programming and Editing operating mode (for TNC data) or
PLC programming (for PLC data) and press the PGMMGT key.
Place the cursor on the USB0:\ directory
If required, you can create a new directory (e.g. data backup) on the flash drive. Enter the name
of the new directory and confirm with the ENT key and the YES soft key.
HEIDENHAIN Service Manual iTNC 530