HEIDENHAIN iTNC 530 Service Manual page 583

MP Function and input
MP332.x Number of signal periods for the distance in MP331
Input:
MP334.x Nominal increment between two fixed reference marks on encoders with distance-
coded reference marks
Input:
0: 1 000
MP340.x Interpolation factor for external interpolation
Input:
0 = 1: No external interpolation
MP410 Assignment of axis keys IV, V and VI
Input:
Axis labels A/B/C/U/V/W/T
MP410.3 IV axis key
MP410.4 V axis key
MP410.5 VI axis key (only HR 5xx)
MP420.x Hirth coupling
Input:
1: Hirth coupling
MP430.x Prescribed increment for Hirth coupling
Input:
MP709.x Time constant for backlash compensation
Input:
MP710.x Backlash compensation
Input:
MP711.x Height of peaks during circular movement (analog only)
Input:
MP712.x Compensation value per control loop cycle time
Input:
MP715.x Height of peaks during circular movement (analog only) with M105
Input:
MP716.x Compensation value per control loop cycle time with M105
Input:
MP720.x Linear axis error compensation
Input:
MP730 Selection of linear/nonlinear axis error compensation
Format:
Input:
0: Linear axis error compensation
1: Nonlinear axis error compensation
MP732 Nonlinear axis-error compensation for rotary axes
Format:
Input:
0: Not active (usual compensation)
1: Active (mapped to traverse range)
July 2010
1 to +1.797693135E+308
1 to 65 535
0 to 99
0: No Hirth coupling
0.0000 to 30.0000 [°]
1 to 1000 [ms]
-9.9999 to +9.9999 [mm] or [°]
-1.0000 to +1.0000 [mm] (digital: 0)
0.000000 to 99.999999 [mm] (digital: 0)
-1.0000 to +1.0000 [mm] (digital: 0)
0.000000 to 99.999999 [mm] (digital: 0)
-1.000 to +1.000 [mm/m]
%xxxxxxxxxxxxxx
Bits 0 to 13 represent axes 1 to 14:
%xxxxxxxxxxxxxx
Bits 0 to 13 represent axes 1 to 14
SW version
and
behavior
PLC
RUN
REF
PLC
RUN
REF
RESET
PLC
RUN
340 490-05
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
340 490-05
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
340 490-03
30 – 583