HEIDENHAIN iTNC 530 Service Manual page 639

MP Function and input
MP7682 Machine parameter with multiple function
Format:
Input:
0: With length compensation
1: Without length compensation
Bit 1 – Reference value for calculating the preset during datum setting
0: Actual value is calculated
1: Nominal value is calculated
Bit 2 – Traverse path of rotary axes with modulo display
0: Positioning without passing over zero
1: Positioning on the shortest path
Bit 3 – Reserved, enter 0
Bit 4 – Tolerance for compensating movements with tilting axes (M114)
0: Tolerance will be included
1: Tolerance will not be included
Bit 5 – Feed rate with M128 or TCPM
0: Feed rate refers to tool tip
1: Feed rate from interpolation of all axes involved
Bit 6 – Behavior with TOOL DEF strobe
0: Depending on the NC-program, the TOOL DEF strobe must be acknowledged by the
PLC (TOOL DEF within a continuous contour)
1: TOOL DEF strobe must always be acknowledged by the PLC
Bit 7 – Block elements TOOL CALL and S in ISO blocks
0: Machine as programmed
1: Machine at beginning of block (block display does not change)
Bit 8 – Behavior of M8 at the end of Cycles 202 and 204
0: At the end of Cycles 202 and 204, the status of M8 is restored to that before the cycle
call (behavior unit now).
1: At the end of Cycles 202 and 204, the status of M8 is not restored automatically.
MP7682 Bit 9 – Loading of "Tilted working plane" status
0: The "tilted working plane" status is not applied to the Manual operating mode after a
program interruption (behavior until now).
1: The "Tilted working plane" status is loaded into the Manual operating mode after a
program interruption.
Bit 10 – Peripheral milling active/inactive
0: Peripheral milling allowed
1: Peripheral milling inactive
Bit 11 – Reserved
July 2010
%xxxxxxxx
Bit 0 – Incremental block after TOOL CALL
SW version
and
behavior
PLC
RUN
340 490-05
30 – 639