HEIDENHAIN iTNC 530 Service Manual page 584

MP Function and input
MP750.x Reversal error (backlash compensation)
Input:
MP752.x Compensation time for reversal error
Input:
MP810.x Display mode for rotary axes and PLC auxiliary axes
Input:
0: Display +/–99 999.9999
1: Modulo value for display
MP812 Activate software limit switches for tilting axes with modulo display, M94 and encoders
with EnDat interface
Format:
Input:
0: Software limit switch not active
1: Software limit switch active
MP850.x Synchronized axes
Input:
0: Master axis
1: Slave axis to axis 1
2: Slave axis to axis 2
3: Slave axis to axis 3
4: Slave axis to axis 4
5: Slave axis to axis 5
6: Slave axis to axis 6
7: Slave axis to axis 7
8: Slave axis to axis 8
9: Slave axis to axis 9
MP855.x Synchronization monitoring
Input:
0: Monitoring not active
MP860.x Datum for synchronous control
Input:
1: Datum at reference marks
2: Axis is torque slave axis
MP910.x Positive software limit switches, traverse range 1 (default setting after power on)
Input:
MP911.x Positive software limit switches, traverse range 2
Input:
MP912.x Positive software limit switches, traverse range 3
Input:
MP920.x Negative software limit switches, traverse range 1 (default setting after power on)
Input:
MP921.x Negative software limit switches, traverse range 2
Input:
MP922.x Negative software limit switches, traverse range 3
Input:
MP950.x Datum for positioning blocks with M92 for axes 1 to 9
Input:
Values with respect to the machine datum
30 – 584
-9.9999 to +9.9999 [mm] or [°]
0 to 1000 [ms]
0.0000 to 99 999.9999 [°]
%xxxxxxxxxxxxxx
Bits 0 to 13 represent axes 1 to 14
0 to 100,0000 [mm]
0: Datum at position after switch-on
-99 999.9999 to +99 999.9999 [mm] or [°]
-99 999.9999 to +99 999.9999 [mm] or [°]
-99 999.9999 to +99 999.9999 [mm] or [°]
-99 999.9999 to +99 999.9999 [mm] or [°]
-99 999.9999 to +99 999.9999 [mm] or [°]
-99 999.9999 to +99 999.9999 [mm] or [°]
-99 999.9999 to +99 999.9999 [mm] or [°]
HEIDENHAIN Service Manual iTNC 530
SW version
and
behavior
PLC
RUN
340 490-04
PLC
RUN
PLC
RUN
REF
RESET
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN