HEIDENHAIN iTNC 530 Service Manual page 629

MP Function and input
MP7461.x Reserved
MP7470 Maximum contouring tool feed rate at 100% override
Input:
0: No limitation
MP7471 Maximum velocity of the principal axes during compensating movements through
M128 or TCPM
Input:
MP7475 Reference for datum table
Input:
1: Reference is machine datum (MP960.x)
MP7480 Output of the tool or pocket number
MP7480.0 With TOOL CALL block
Input:
1: Tool number output only when tool number changes
2: Tool number output for every TOOL CALL block
3: Pocket number and tool number output only when tool number changes
4: Output of the pocket number and tool number for every TOOL CALL block
5: Pocket number and tool number output only when tool number changes. Pocket table
is not changed.
6: Pocket number and tool number output for every TOOL CALL block. Pocket table is
not changed.
MP7480.1 With TOOL DEF block
Input:
1: Tool number output only when tool number changes
2: Tool number output for every TOOL DEF block
3: Pocket number and tool number output only when tool number changes
4: Pocket number and tool number output for every TOOL DEF block
July 2010
0 to 300 000 [mm/min]
0 to 300 000 [mm/min]
0: Reference is workpiece datum
0: No output
0: No output
SW version
and
behavior
340 422-10,
340 480-10
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
30 – 629