HEIDENHAIN iTNC 530 Service Manual page 141

Operand Description
M 4222 Error from PET table with EM. STOP active
M 4223 Error from PET table with NC Cancel active
M 4225 Activate alternative error reaction
M 4227 PLC error message with priority 0 (error)
M 4228 PLC error message with priority 1 (warning)
M 4229 PLC error message with priority 2 (info)
M 4230 NC start via LSV2
M 4231 NC stop via LSV2
Markers influenceable by machine parameters
Operand Description
M 4300 - Value from MP4310.0
4315
M 4316 - Value from MP4310.1
4331
M 4332 - Value from MP4310.2
4347
M 4348 - Value from MP4310.3
4363
M 4364 - Value from MP4310.4
4379
M 4380 - Value from MP4310.5
4395
M 4396 - Value from MP4310.6
4411
Tool change
Operand Description
M 4520 Additional T code (P code) follows with TOOL CALL
M 4521 Tool number zero programmed
M 4522 Tool with pocket number programmed is in effect with
MP7480.0 = 3 or 4 and TOOL CALL
M 4523 Tool without pocket number programmed is in effect with
MP7480.0 = 3 or 4 and TOOL CALL
M 4524 Special tool called, TOOL CALL
M 4525 TOOL CALL after expiration of tool life
M 4526 - Axis 1 to axis 9 is the tool axis
4534
M 4538 Geometry of the tool from W264
M 4539 Tool number highlighted in the status display
M 4540 Sequence of tool number or pocket number transfer (M4520 = 1)
M 4541 Special tool in original pocket in spite of variable pocket coding
M 4542 Do not update pocket number in the pocket table
M 4543 Tool life 1 expired (TIME1 in the tool table)
M 4546 Tool life 2 expired (TIME2 in the tool table)
M 4547 T and G strobes with TOOL CALL
July 2010
Set Reset As of SW vers.
NC NC
NC NC 340 422-10,
340 480-10
340 49x-04
NC NC 340 422-10,
340 480-10
NC NC 340 422-10,
340 480-10
NC NC 340 422-10,
340 480-10
NC NC
NC NC
Set Reset As of SW vers.
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
Set Reset As of SW vers.
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
PLC NC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
NC NC/
PLC
NC NC/
PLC
NC NC
11 – 141