HEIDENHAIN iTNC 530 Service Manual page 108

Other soft keys are available:
Other soft keys
Meaning of the soft keys:
You find the cursor information at the bottom left below the channel display and the time bar.
Cursor
First, the signal amplitude of the selected channel and the time (related to the trigger event)
information
are displayed here.
With the CURSOR 1/2 soft key, you can activate a second cursor.
For the cursor 2 the signal amplitude and the time (in seconds) are displayed in relation to
cursor 1. This function allows you for example to measure the acceleration time of an axis.
Figure: Cursor information
10 – 108
Hide/show gridlines.
Hide/show connecting lines between measured points.
Invert the signal.
Exit the oscilloscope function.
Note
Grid points that were recorded before the trigger condition was fulfilled are given a negative
time.
Cursor information
T1:
A1:
T2:
A2:
Comment
Position of cursor 1 in [s], related to the trigger event
Signal amplitude at position of cursor 1
Position of cursor 2 in [s], related to cursor 1 (time difference)
Signal amplitude at position of cursor 2, related to signal amplitude
at position of cursor 1
HEIDENHAIN Service Manual iTNC 530