HEIDENHAIN iTNC 530 Service Manual page 619

MP Function and input
MP7245 Disabling auxiliary cycles
Input:
1: Auxiliary cycles permitted
MP7246 Machine parameter with multiple function
Input:
Bit 0 – Paraxial positioning blocks
0: Permitted
1: Locked
Bit 1 – Clear with DEL key
0: Does not need confirmation
1: Must confirm via soft key
Bit 2 – Tool usage file
0: Do not generate
1: Generate
Bit 3 – Settings file for AFC
0: Do not generate
1: Generate
Bit 4 – ASCII file for machining time per NC block
0: Do not create ASCII file for machining time per NC block
1: Create ASCII file for machining time per NC block
MP7251 Number of global Q parameters starting from Q99 (up to Q60) that are transferred from
the OEM cycle to the calling program.
Input: 0 to 40
MP7260 Number of tools in the tool table
MP7260 can also be overwritten by the PLC and the LSV2 protocol.
Input:
MP7261.0-7 Number of pockets in the tool magazine 1 to 8
MP7261 can also be overwritten by the PLC and the LSV2 protocol.
Input:
MP7262 Maximum tool index number for indexed tools
MP7262 can also be overwritten by the PLC and the LSV2 protocol.
Input:
MP7263 Pocket table
MP7263 can also be overwritten by the PLC and the LSV2 protocol.
Format:
Input:
0: Show POCKET TABLE soft key
1: Hide POCKET TABLE soft key
Bit 1 – Output of the columns for file functions
0: Output only the displayed columns
1: Output all columns
Bit 2 – Show the "Edit ON/OFF" soft key in the pocket table
0: Display soft key
1: Do not display soft key
Bit 3 – Soft keys "Reset pocket table" and "Reset column T"
0: Display soft key
1: Do not display soft key
July 2010
0: Auxiliary cycles disabled
%xxxx
0 to 30 000
0 to 9999
0 to 9
%xx
Bit 0 –
SW version
and
behavior
PLC
RUN
PLC
RUN
340 490-04
PLC
RUN
CN123
340 490-03
CN123
340 490-05
CN123
340490-03
CN123
340490-05
30 – 619