HEIDENHAIN iTNC 530 Service Manual page 140

C operating modes and status
Operand Description
M 4150 Operating mode: Manual Operation
M 4151 Operating mode: Electronic Handwheel
M 4152 Operating mode: Positioning with Manual Data Input
M 4153 Operating mode: Program Run, Single Block
M 4154 Operating mode: Program Run, Full Sequence
M 4155 Operating mode: Reference-Mark Traverse
M 4156 MANUAL TRAVERSE soft key pressed
M 4157 Returning to the contour (MOVE TO POSITION) is active
M 4158 Block scan active
M 4159 PLC editor: END key or soft key pressed
M 4160 Pallet table selected
M 4161 M/S/T/Q transfer after block scan
M 4162
DNC mode (0=DNC inactive, 1=DNC active)
M 4163 Alternative operating mode smarT.NC is active
M 4170 END PGM, M02 or M30 was executed
M 4172 1. PLC cycle after power on
M 4173 1. PLC scan after interruption of the PLC program
M 4174 1. PLC scan after editing the MPs (MP edit was exited and the MPs
were altered)
M 4175 Program interruption, control-in-operation symbol is blinking
M 4176 Control is in operation, control-in-operation symbol is on or is blinking NC
M 4177 Clearable error message displayed
M 4178 Error message EMERGENCY STOP is displayed
M 4179 Control is being shut down
M 4180 Rapid traverse programmed (FMAX)
M 4181 NC program selected
M 4182 AUTOSTART active
M 4183 Time from AUTOSTART expired
M 4185 Internal stop performed
M 4186 NC program is active in the Test Run mode
M 4188 Compilation process of the PLC project active
M 4189 EMERGENCY STOP test during control start-up completed
Arithmetic or Module Error in the PLC
Operand Description
M 4200 Overflow during multiplication
M 4201 Division by 0
M 4202 Incorrectly executed modulo
M 4203 Error status for PLC module
M 4204 Reserved for errors that the PLC programmer would like to catch
M 4210 Error from Python script with F stop active
M 4211
Error from Python script with NC stop active
M 4212
Error from Python script with EM. STOP active
M 4213 Error from Python script with NC Cancel active
M 4220 Error from PET table with F stop active
M 4221 Error from PET table with NC stop active
11 – 140
Set Reset As of SW vers.
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC/
PLC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC NC
NC
NC NC
NC NC
NC NC
NC NC
NC PLC
NC NC
NC NC
NC PLC 340 420-06
NC PLC 340 49x-01
NC PLC 340 49x-04
NC PLC 340 49x-05
Set Reset As of SW vers.
NC PLC
NC PLC
NC PLC
NC NC/
PLC
NC NC
NC NC 340 49x-04
NC NC 340 49x-04
NC NC 340 49x-04
NC NC 340 49x-04
NC NC
NC NC
HEIDENHAIN Service Manual iTNC 530