HEIDENHAIN iTNC 530 Service Manual page 578

When you have finished error diagnosis or various tests at the machine, you will normally restore
Restoring original
the original settings.
settings
Figure: Active MP list in the program manager
30 – 578
Your are in the Machine parameter programming mode.
Call the program management.
Place the cursor on the original MP list.
Load this file into the editor.
Press the END key (the iTNC 530 activates the selected original MP file and
performs a reset, if necessary).
Note
In the program management, the active MP file has the entry M in the status column.
HEIDENHAIN Service Manual iTNC 530