3.3
Input of Code Numbers
When you have finished your work, reset all previously entered code numbers:
3 – 18
Select the Programming and Editing operating mode.
If open: Close the program management by pressing the END button.
Note
Pressing the MOD key while the program manager is open calls the interface settings.
Call the code number window.
Note
When certain code numbers are entered, new soft keys are displayed, MP EDIT,
PLC EDIT, OSCI.
With these soft keys you can also change to the corresponding areas without having to
enter the code number again.
Enter the code number 0 and press ENT to confirm.
Press END to exit the code-number page.
Note
All key codes are reset when the control is restarted.
Enter the code number and press ENT to confirm.
HEIDENHAIN Service Manual iTNC 530