Overviews - HEIDENHAIN iTNC 530 Service Manual

11.5 Overviews

The following tables are excerpts from the iTNC 530 Technical Manual of May 2009.
A list of PLC operands with brief description in English and German (GLB_NC_de.DEF,
Overview of
GLB_NC_en.DEF) is available on the control under PLC:\JH\.
markers
Operand Description
M 1900 - Decoded M function if M4571 is set
1999
Spindle
Operand Description
M 4000 Spindle in position
M 4001 Nominal speed command signal of the spindle not in the ramp
M 4002 Nominal speed value = 0
M 4003 Nominal speed value output analog or digital (MP3010 = 3 to 8)
M 4004 Impermissible speed was programmed
M 4005 Status display and nominal speed value output for M03
M 4006 Status display and nominal speed value output for M04
M 4007 Status display M05 and spindle stop
M 4008 Disable speed output for spindle
M 4009 Counterclockwise spindle rotation (for gear change)
M 4010 Clockwise spindle rotation (for gear change)
M 4011 Activate rotational speed MP3520.0 and rotational direction M4013
M 4012 Open the spindle control loop
M 4013 Direction for spindle orientation from a standstill (M03 = 0; M04 = 1)
M 4014 Reverse the direction of spindle rotation
M 4015 Renewed evaluation of the spindle reference mark
M 4016 Cycle 13 is executed
M 4017 Servo-controlled spindle in motion
M 4018 Reference mark for spindle not yet traversed
M 4019 Reversing the counting direction of position encoder on the spindle
Thread cutting
Operand Description
M 4030 Cycle 2 or Cycle 17 active
M 4031 Cycle 17 or cycle 18 active
Coolant status
Operand Description
M 4040 Status display M07, M08, and M09 highlighted
M 4041 Status display M07, M08, M09, MK
M 4042 Status display M07, M08, M09, MK
Touch probe
Operand Description
M 4050 Touch probe not ready, ready signal is missing
M 4051 Stylus deflected before start of probing cycle
M 4052 Stylus is deflected, probing process is completed
11 – 138
Set Reset As of SW vers.
NC NC
Set Reset As of SW vers.
NC NC
NC NC
NC NC
NC NC
NC NC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC PLC
PLC NC
NC PLC
NC NC
NC NC
PLC PLC
Set Reset As of SW vers.
NC NC
NC NC
Set Reset As of SW vers.
PLC PLC
PLC PLC
PLC PLC
Set Reset As of SW vers.
NC NC
NC NC
NC PLC
HEIDENHAIN Service Manual iTNC 530