18.6 Switching over the Position Display for Servicing
When servicing it is often important to switch over the position display (e.g., to REF when
resetting the machine datum).
Call
Possible position displays:
Description of the
settings
ACTL.
REF
LAG
SOLL
DIST.
DG 3D
M118
July 2010
Press the following key combination to switch the position display:
Select a machine operating mode (Manual Operation, Program Run, Full
Sequence, etc.).
Press the MOD key.
Press GOTO. --> A selection window is opened.
Actual position
Distance to machine datum
Current following error
Nominal position
Distance-to-go in the machine coordinate system
Distance-to-go in a tilted coordinate system
Handwheel superimposition during program run
Using the arrow keys, select the desired position display.
Press ENTER to activate the position display.
Close window.
18 – 315