HEIDENHAIN iTNC 530 Service Manual page 589

MP Function and input
MP1200 Selection of the nominal position value filter used
Input:
1: Double filter
2: HSC filter
3: Advanced HSC filter
MP1201 Nominal position value filter in manual operation
Input:
1: Double filter
MP1202 Predefined tolerance for Cycle 32
Input:
MP1202.0 Tolerance at corners for movements at machining feed rate
MP1202.1 Tolerance at corners for movements at rapid traverse
MP1205 Reduction of the contouring feed rate at the beginning of a contour element
Input:
1: Active (slow but likely more precise)
MP1210 Limit frequency for single filter
Input:
0.0 to 166.0 [Hz]
MP1211 Limit frequency for double filter
Input:
0.0 to 166.0 [Hz]
MP1212 Limit frequency for HSC filter
Input:
0.0 to 166.0 [Hz]
MP1213 Limit frequency for advanced HSC filter
Input:
0.0 to 166.0 [Hz]
MP1222 Tolerance for curvature changes with HSC filter (only effective if MP7684 bit 4 = 0)
Entry:
1: Include the tolerance
MP1223 Tolerance for curvature changes with advanced HSC filter (only effective if MP7684 bit
4 = 0)
Entry:
1: Include the tolerance
MP1230.x Max. permissible axis-specific jerk at corners for single filter
Input:
MP1231.x Max. permissible axis-specific jerk at corners for double filter
Input:
MP1232.x Max. permissible axis-specific jerk at corners for HSC filter
Input:
MP1233.x Max. permissible axis-specific jerk at corners for advanced HSC filter
Input:
July 2010
0: Single filter
0: Single filter
0.0000 to 3.0000 [mm]
0: Not active (fast, possibly less precise)
0: Filter is switched off
0: Filter is switched off
0: Filter is switched off
0: Filter is switched off
0: Do not include the tolerance
0: Do not include the tolerance
0.1 to 1000.0 [m/s³]
0.1 to 1000.0 [m/s³]
0.1 to 1000.0 [m/s³]
0.1 to 1000.0 [m/s³]
SW version
and
behavior
340 490-01
PLC
RUN
340 490-01
PLC
RUN
340 490-01
PLC
RUN
340 490-03
340 490-01
PLC
340 490-01
PLC
340 490-01
PLC
340 490-01
PLC
340 490-01
PLC
RUN
340 490-01
PLC
RUN
340 490-01
PLC
RUN
340 490-01
PLC
RUN
340 490-01
PLC
RUN
340 490-01
PLC
RUN
30 – 589