Code Numbers; Introduction; Overview - HEIDENHAIN iTNC 530 Service Manual

3

Code Numbers

3.1

Introduction

With code numbers ...
... can be called.
3.2

Overview

Code number Brief description
Delete the code numbers entered so far --> Code-number
0
softkeys, such as MP EDIT or PLC EDIT are deleted.
Edit subset of machine parameters for the machine operator
123
Offset adjustment for analog axes
75368
Info menu (U[BATT], U[ACCU], U[VCC], TEMP, T[CPU1]),
79513
Call the active machine parameter list
95148
Reset non-volatile PLC markers and PLC words in the RAM
531210
Integrated oscilloscope
688379
Call the PLC area
807667
Reset the operating times
857282
Call and save the internal log of the TNC
LOGBOOK
Network settings for the single-processor control
NET123
Call for loading of service packs and NC software for the single-
SETUP
processor control
Display of the number of the system identification key and of the
SIK
enabled options
Create the file TNC:\Version.a
VERSION
System data is saved in this file for diagnostic purposes. The file
can be read out for diagnosis.
July 2010
certain areas of the hard disk
certain file types
certain functions
DANGER
Code numbers may only be passed on to and be used by trained service technicians.
Keep the code numbers confidential!
Inexpert handling may result in a loss of important data, in faulty machine performance and
thus lead to damage or injury to property or persons.
Note
The machine manufacturer can define own MP and PLC code numbers.
In this event the HEIDENHAIN code numbers do not function any longer, or only function to
a limited extent. --> Contact your machine manufacturer!
Description in
this manual
In this chapter
See page 30 - 571
See page 20 – 349
See page 17 – 267
See page 30 – 572
See page 11 – 133
See page 10 – 99
See page 11 – 115
-
See page 8 – 81
See page 13 – 172
See page 15 – 219
See page 28 – 525
-
3 – 17