HEIDENHAIN iTNC 530 Service Manual page 604

MP Function and input
MP3143 Mounting configuration of the spindle position encoder
Input:
1: Position encoder via transmission (ratio in MP3450.x and MP3451.x); X30 pin 1:
reference pulse
2: Position encoder via transmission (ratio in MP3450 and MP3451); X30 pin 1:
reference pulse release
3: Same as input value 1, except that the second reference pulse is evaluated.
MP3210.0-7 Analog nominal spindle voltage at rated speed for the gear ranges 1 to 8
Input:
Digital spindle motor revolutions at rated speed for the gear ranges 1 to 8
Input:
MP3240.1 Analog spindle: Minimum nominal value voltage
Input:
Digital spindle: Minimum motor speed
Input:
MP3240.2 Analog spindle: Spindle jog voltage for gear shifting (M4009/M4010)
Input:
Digital spindle: Motor speed for gear shifting (M4009/M4010)
Input:
MP3310 Limitation for spindle speed override
Input:
MP3310.0 Upper limit
MP3310.1 Lower limit
MP3350 Maximum permissible overshoot of the spindle speed in percent of the nominal spindle
speed
Input:
MP3351 Entry of an absolute value for the permissible overshoot of the spindle speed
Input:
0 = Monitoring off
MP3411.0-7 Ramp gradient of the spindle with M03 and M04 for gear ranges 1 to 8
Input:
Digital axes: 0 to 1.999 [(1000 rpm)/ms]
MP3412 Multiplication factor for MP3411.x
Input:
MP3412.0 With M05
MP3412.1 With oriented spindle stop
MP3412.2 With tapping with floating tap holder
MP3412.3 With rigid tapping
MP3415 Overshoot behavior of the spindle with M03, M04 and M05
Input:
MP3415.0 With M03, M04 and M05
MP3415.1 For oriented spindle stop
MP3415.2 With tapping
MP3415.3 With rigid tapping
MP3420 Spindle positioning window
Input:
MP3430 Deviation of the reference mark from the desired position (spindle preset)
Input:
30 – 604
0: Position encoder directly on the first spindle
0 to 100.000 [V]
0 to 100,000 [1000 rpm]
0 to 9.999 [V]
0 to 100,000 [1000 rpm]
0 to 9.999 [V]
0 to 100,000 [1000 rpm]
0 to 150 [%]
0 to 100 [%]
0.001 to 100000.000 [U/min]
Analog axes: 0 to 1.999 [V/ms]
0.000 to 1.999
0 to 1000 [ms]
0 to 360.0000 [°]
0 to 360 [°]
HEIDENHAIN Service Manual iTNC 530
SW version
and
behavior
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
340 490-03
340 490-03
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN