HEIDENHAIN iTNC 530 Service Manual page 621

MP Function and input
MP7267 Elements of the pocket table
MP7267 can also be overwritten by the PLC and the LSV2 protocol.
Input:
1 to 99: Position in the pocket table
MP7267.0 Tool number (T)
MP7267.1 Special tool (ST)
MP7267.2 Fixed pocket (F)
MP7267.3 Locked pocket (L)
MP7267.4 PLC status (PLC)
MP7267.5 Tool name (TNAME)
MP7267.6 Comment on the tool (DOC)
MP7267.7 Tool type for pocket table (PTYP)
MP7267.8 Value 1 (P1)
MP7267.9 Value 2 (P2)
MP7267.10 Value 3 (P3)
MP7267.11 Value 4 (P4)
MP7267.12 Value 5 (P5)
MP7267.13 Reserve pocket (RSV)
MP7267.14 Pocket above locked (LOCKED_ABOVE)
MP7267.15 Pocket below locked (LOCKED_BELOW)
MP7267.16 Pocket at left locked (LOCKED_LEFT)
MP7267.17 Pocket at right locked (LOCKED_RIGHT)
MP7267.18 S1 value (P6)
MP7267.19 S2 value (P7)
MP7270 Feed rate display in the operating modes MANUAL OPERATION and ELECTRONIC
HANDWHEEL
Input:
specific feed rate from MP1020)
1: Display of axis feed rate also before an axis direction key is pressed (smallest value
from MP1020 for all axes)
MP7280 Decimal character
Input:
1: Decimal period
MP7281 Depiction of the NC program
Input:
1: Current block completely, others line by line
2: All blocks line by line; complete block when editing
MP7285 Tool length offset in the tool-axis position display
Input:
1: Tool length is offset
MP7289 Position display step for the spindle
Input:
1: 0,05°
2: 0,01°
3: 0,005°
4: 0,001°
5: 0,0005°
6: 0,0001°
July 2010
0: No display
0: Display of axis feed rate through pressing an axis direction key (axis-
0: Decimal comma
0: All blocks completely
0: Tool length is not offset
0: 0.1°
SW version
and
behavior
SZ123
340 490-03
340 420-02
340 490-05
340 490-05
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
30 – 621