HEIDENHAIN iTNC 530 Service Manual page 191

Figure: Read-out file
In the lower screen half (iTNC 530 contents), select the target drive and the target directory:
Reading in data
using TNCremoNT
In the upper screen half (laptop/PC contents), select the source drive and the source
directory:
Transfer the data:
July 2010
Note
During downloading the data format is automatically converted from BINARY (control) to
ASCII (laptop/PC) via TNCremoNT.
Click the bar with the drive information. --> Its color changes from gray to blue, and two
buttons appear at the right side in the bar.
Click the Change folder/drive... button. --> A new window opens.
Now, select the drive and the folder. --> The path is displayed in the blue bar.
Note
For changing to the PLC: und SYS: control partitions, the respective code numbers are
interrogated.
Click the bar with the drive information. --> Its color changes from gray to blue, and two
buttons appear at the right side in the bar.
Click the Change folder/drive... button. --> A new window opens.
Now, select the drive and the folder. --> The path is displayed in the blue bar.
Using the mouse, click the directory you wish to read in.
Press and hold the left mouse button and pull the directory or the file into the lower window.
Release the mouse button. --> The file is being transferred.
Note
During uploading the data format is automatically converted from ASCII (laptop/PC) to
BINARY (control) via TNCremoNT.
13 – 191