HEIDENHAIN iTNC 530 Service Manual page 444

The iTNC 530 is currently equipped with the following NC software versions:
Hardware
Single-processor
Dual-processor
(with Windows 2000
or Windows XP)
Due to restrictions on the export of the iTNC 530, HEIDENHAIN can also supply a special export
version (until now all NC software versions with odd character parity).
HEIDENHAIN releases a new program number for the NC software whenever it introduces
extensive new functions.
PLC software
BASIS--51
Preset table
ON
OFF
Options
%
0000111100000000
DSP software
246261
27
26 – 444
Standard SW
340 420-xx
340 422-xx
340 490-xx
340 480-xx
340 492-xx
Random character sequence which the machine manufacturer uses to
identify his PLC software
Preset table active
Preset table not active
Identifier of binary format
Options enabled in the SIK (e.g. auxiliary axes, tilting
operation, HSC milling etc.)
Program number of DSP software
Version of the DSP software
Note
The DSP software designates the operating system for the digital signal processors (DSP)
that are responsible for the speed control of digital axes/spindles:
DSP1: Software for the main controller board
DSP2: Software for the add. controller board
Export SW Comment
340 421-xx without preset tables
340 423-xx with preset tables
340 491-xx with preset tables and smarT.NC
programming surface
340 481-xx with preset tables
340 493-xx with preset tables and smarT.NC
programming surface
HEIDENHAIN Service Manual iTNC 530