HEIDENHAIN iTNC 530 Service Manual page 607

MP Function and input
MP4042 PLC output to be set after shutdown
Input: 0 to 31
MP4043 Delay during shutdown for the PLC to execute final actions
Input:
0: No delay
MP4044 Switch off outputs that cannot be switched off by emergency stop after 250-ms delay
Input:
Bits 0 to 7 correspond to O16 to O23
0: Do not switch off output with delay
1: Switch off output with delay
MP4045 Switch off outputs that cannot be switched off by emergency stop after 250-ms delay
Input:
Bits 0 to 6 correspond to O24 to O30
0: Do not switch off output with delay
1: Switch off output with delay
MP4050.0-8 Traverse distance for lubrication of axes 1 to 9
Input: 0 to 99 999.999 [m or 1000°]
MP4060.0-3 Outputs that are to be switched off with the delay from MP4061.x when all outputs are
switched off
Input:
MP4061.0-3 Delay time for switching off the outputs in MP4060.x
Input:
MP4070 Compensation amount per PLC cycle for lagged-tracking axis error compensation
Input:
MP4110.0-47 Run time PLC timer T0 to T47
Input: 0 to 1 000 000.000 [s]
MP4111.96-x Run time PLC timer T96 to x (defined in OEM.SYS)
Input: 0 to 1 000 000.000 [s]
MP4120.0-47 PLC counter preset value
Input: 0 to 1 000 000.000 [s or PLC cycles, depending on MP4020, bit 11]
MP4130.0 Number of the high-speed PLC input for switching off the monitoring functions
MP4130.1 Reserved
MP4130.2-5 Numerical designation for fast PLC inputs
Input:
July 2010
1 to 60 [s]
%xxxxxxxx
% xxxxxxx
0 to 30 [no. of the output]
–1: Do not switch off any outputs with delay
0 to 5.000 [s]
0.0001 to 2.0000 [mm]
0 to 255 [no. of the PLC input]
SW version
and
behavior
340 420-03
PLC
RUN
340 490-04
PLC
RUN
340 422-07,
340 480-07
Only until
340 422-09,
340 480-09
PLC
RUN
340 420-08
Only until
340 422-09,
340 480-09
PLC
RUN
PLC
RUN
340 422-09,
340 480-09
PLC
340 422-09,
340 480-09
PLC
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
30 – 607