HEIDENHAIN iTNC 530 Service Manual page 177

Up to NC software 340 49x-04:
July 2010
Press the INSERT LINE soft key.
Note
If the INSERT LINE soft key is not available with older NC software versions -->
note down the original settings, before you overwrite them or generate a backup copy of
the file (ip4n00.a).
Enter a suitable IP address.
Note
We recommend using the IP address of the laptop and increasing the last place by one.
Example:
Address of the laptop
Address of the iTNC 530
Enter the same subnet mask as that of your laptop.
Note
If the message Protected file! appears while entering the new settings, the write
protection for the file ip4.n00 must be disabled:
Exit network settings --> Enter PLC code number --> Call program management --> Place
cursor in the NET folder on file ip4.n00 --> Switch to the next soft-key row --> Press MORE
FUNCTIONS soft key --> Cancel locking --> P (Protected) disappears in the status column.
Now you can change the network settings.
Press the INSERT LINE soft key.
Press the END key twice.
Now the control reboots, the new settings are active.
160.1.11.227
160.1.11.228
13 – 177