Setting The Condition Data; Relation Between Various Controls And The Condition Data - Mitsubishi Electric MELSEC-Q QD75M User Manual

10 HIGH-LEVEL POSITIONING CONTROL

10.4 Setting the condition data

10.4.1 Relation between various controls and the condition data

"Condition data" is set in the following cases.
(1) When setting conditions during execution of Section 9.2.21 "JUMP instruction"
(major positioning control)
(2) When setting conditions during execution of "high-level positioning control"
The "condition data" to be set includes the 5 setting items from
the setting requirements and details differ according to the control system and setting
conditions.
The following shows the "condition data
different types of control.
(The "condition data" settings in this chapter are assumed to be carried out using GX
Configurator-QP.)
Control type
Da.15
Setting item
01: Device X
02: Device Y
03: Buffer memory
(1 word)
04: Buffer memory
(2 words)
05: Positioning data
No.
: One of the setting items must be set.
: Setting not possible
REMARK
It is recommended that the "condition data" be set whenever possible with GX
Configurator-QP. Execution by PLC program uses many PLC programs and
devices. The execution becomes complicated, and the scan times will increase.
Da.15
High-level positioning control
Block Wait Simultaneous
start start start
10 - 16
Da.15 to
Condition target" corresponding to the
Repeated start
(For condition)
MELSEC-Q
Da.19 , but
Major positioning
control
JUMP instruction