Positioning Program Examples - Mitsubishi Electric MELSEC-Q QD75M User Manual

6 PLC PROGRAM USED FOR POSITIONING CONTROL
MELSEC-Q

6.4 Positioning program examples

An example of the "Axis 1" positioning program is given in this section.
[No. 1] to [No. 3] parameter and data setting program
When setting the parameters or data with the PLC program, set them in the QD75 using the
TO command from the PLC CPU. (Carry out the settings while the PLC READY signal [Y0] is
OFF.)
When setting the parameters or data with GX Configurator-QP, the [No. 1] to [No. 3] program
is not necessary.
6 - 20