Outline For Restarting - Mitsubishi Electric MELSEC-Q QD75M User Manual

1 PRODUCT OUTLINE

1.2.4 Outline for restarting

Axis 1
Stop position due to stop cause
400
Start point
address
200
100
100
Reference
Provide the emergency stop circuits external to the servo system to prevent cases
where danger may result from abnormal operation of the overall in the event of a
power supply fault or servo system failure.
When a stop cause has occurred during operation with position control causing the
axis to stop, positioning to the end point of the positioning data can be restarted from
the stopped position by using the "
If issued during a continuous positioning or continuous path control operation, the
restart command will cause the positioning to be re-executed using the current position
(pointed by the positioning data No. associated with the moment when the movement
was interrupted) as the start point.
When " Cd.6 Restart command" is ON
Md.26
(1) If the " Axis operation status" is stopped, positioning to the end point of
the positioning data will be restarted from the stopped position regardless of
the absolute system or incremental system.
(2) When " Md.26
possible" (warning code: 104) will be applied, and the restart command will be
ignored.
[Example for incremental system]
(a) The restart operation when the axis 1 movement amount is 300, and the
axis 2 movement amount is 600 is shown below.
Designated end
point position
300 700
Reference
If the positioning start signal [Y10 to Y13]/external command signal
Md.26
while the " Axis operation status" is waiting or stopped, positioning will be
restarted from the start of the positioning start data regardless of the absolute
system or incremental system. ( : When the external command signal is set to
"External positioning start")
(Same as normal positioning.)
Cd.6
Restart command".
Axis operation status" is not stopped, the warning "Restart not
400
Restart
200
100
Axis 2
1 - 27
Axis 1
Stop position due to stop cause
100 300
MELSEC-Q
Stop position
after restart
Operation during
restart
Axis 2
700
is turned ON