Dual Range Mode (Dual) - Teledyne T360 Operation Manual

Teledyne API Model T360/T360M Operation Manual

4.8.4. Dual Range Mode (DUAL)

SAMPLE* RANGE = 500.000 PPM
< TST TST > CAL
PRIMARY SETUP MENU
SETUP X.X
CFG DAS RNGE PASS CLK MORE
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
SETUP X.X RANGE MODE:
SNGL DUAL AUTO
In DUAL range mode the LOW and HIGH ranges have separate slopes and offsets for computing
07272B DCN6552
Selecting Dual Range mode allows the A1 and A2 outputs to be configured with
different reporting ranges. The analyzer software calls these two ranges low and
high. The low range setting corresponds with the analog output labeled A1 on the
Rear Panel of the instrument. The high Range Setting corresponds with the A2
output. While the software names these two ranges low and high, they do not
have to be configured that way. For example: The low range can be set for a span
of 0-1000 ppm while the high range is set for 0-500 ppm.
In DUAL range mode the RANGE test function displayed on the front panel will
be replaced by two separate functions:

RANGE1 : The range setting for the A1 output.

RANGE2 : The range setting for the A2 output.
To set the ranges press following menu button sequence
CO2 =X.XXX
SETUP
EXIT
EXIT
SNGL
ENTR EXIT
When the instrument's range mode is set to DUAL the concentration field in the
upper right hand corner of the display alternates between displaying the low
range value and the high range value.
displayed is identified as follows: C1 = Low (or A1) and C2 = High (or A2).
CO
2
The two ranges must be independently calibrated.
.
SETUP X.X RANGE MODE:
SNGL DUAL AUTO
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
SETUP X.X LOW RANGE: 500.0 Conc
0 0 1 0 0
SETUP X.X HIGH RANGE: 500.0 Conc
0 0 5 0 0
SETUP X.X RANGE CONTROL MENU
MODE SET UNIT
The concentration currently being
NOTE
concentration.
Operating Instructions
DUAL
ENTR EXIT
EXIT
Toggle the
.0 ENTR EXIT
numeral buttons
to set the upper
limit of each
.0 ENTR EXIT
EXIT SAMPLE Display
range.
EXIT Returns
to the Main
99