A1 & A2 Dual Range Mode - Teledyne 300E Instruction Manual

Operating Instructions
Set Range value
between
1.0 and 1,000 ppm
Remember, while both A1 and A2 are reporting the same data within the same
Measurement Range span, their respective electronic signal levels can still be
configured differently (see Section 6.5) to meet the input requirements of different
recording devices.
6.4.4. A1 & A2 Dual Range Mode
Selecting Dual Range mode allows the A1 and A2 outputs to be configured with
different measurement spans.
The analyzer software calls these two ranges Low and High. The Low range setting
corresponds with the analog output labeled A1 on the Rear Panel of the instrument.
The Higher Range Setting corresponds with the A2 output. While the software
names these two ranges Low and High, they do not have to be configured that way.
66
SAMPLE RANGE = 50.0 PPM
< TST TST > CAL
SETUP C.3
CFG DAS RNGE PASS CLK MORE
SETUP C.3 RANGE CONTROL MENU
MODE SET UNIT
SETUP C.3 RANGE MODE: SNGL
SNGL DUAL AUTO
SETUP C.3 RANGE MODE: SNGL
SNGL DUAL AUTO
SETUP C.3 RANGE CONTROL MENU
MODE SET UNIT
SETUP C.3 RANGE: 50.0 Conc
0 0 0 5 0
SETUP C.3 RANGE CONTROL MENU
MODE SET UNIT
Model 300E Carbon Monoxide Analyzer
CO =
SETUP
EXIT
EXIT
Range mode
Defaults to SNGL
ENTR EXIT
ENTR
EXIT
EXIT
.0 ENTR EXIT
EXIT Returns
EXIT SAMPLE Display
Instruction Manual
to the Main
P/N 04288 REV: A