Table of Contents
Advertisement
Operating Instructions
6.9.8. Ethernet Configuration (Optional Hardware)
When equipped with the optional Ethernet interface, the analyzer can be connected
to any standard 10BaseT Ethernet network via low-cost network hubs, switches or
routers. The interface operates as a standard TCP/IP device on port 3000. If
Internet access is available through the LAN, this option also allows communication
with the instrument over the public Internet.
The option consists of a Teledyne Instrument's designed Ethernet card, which is
mechanically attached to the instrument's rear panel (Figure 2-6). A 7-foot long
CAT-5 network cable, terminated at both ends with standard RJ-45 connectors, is
included as well. Maximum communication speed is limited by the RS-232 port to
115.2 kBaud.
When installed, this option is electronically connected to the instrument's COM2
serial port making that port no longer available for RS-232/RS-485 communications
through the COM2 connector on the rear panel. Once the Ethernet option is
installed and activated, the COM2 submenu is replaced by a new submenu, INET.
This submenu is used to manage and configure the Ethernet interface with your
LAN or Internet Server(s).
Rear Panel
Ethernet
(as seen from inside)
Card
Female RJ-45
Connector
LNK LED
ACT LED
TxD LED
RxD LED
Figure 2-6:
126
CPU
Card
RE-232
Connector To
Motherboard
Interior View
M400E Rear Panel with Ethernet Installed
Model 400E Ozone Analyzer
Instruction Manual
Exterior View
P/N 04316 Rev: B
Advertisement
Table of Contents
