Hot Links Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

Hot Links Configuration

© Copyright Lenovo 2017
Use these commands to configure Hot Links. For more information about Hot
Links, see "Hot Links" in the Lenovo RackSwitch G8264CS Application Guide for
Lenovo Enterprise Network Operating System 8.4.
Table 241.
Hot Links Configuration Options
Command Syntax and Usage
[no] hotlinks bpdu
Enables or disables flooding of Spanning‐Tree BPDUs on the active Hot Links
interface when the interface belongs to a Spanning Tree group that is globally
turned off. This feature can prevent unintentional loop scenarios (for
example, if two uplinks come up at the same time).
The default setting is disabled.
Command mode: Global configuration
[no] hotlinks enable
Globally enables or disables Hot Links.
Command mode: Global configuration
[no] hotlinks fdb­update
Enables or disables FDB Update, which allows the switch to send FDB and
MAC update packets over the active interface.
The default value is disabled.
Command mode: Global configuration
hotlinks fdb­update­rate <10‐1000>
Configures the FDB Update rate in packets per second.
Command mode: Global configuration
show hotlinks
Displays current Hot Links parameters.
Command mode: All
Chapter 4: Configuration Commands
451