Ospfv3 Area Index Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

OSPFv3 Area Index Configuration
© Copyright Lenovo 2017
Table 274.
OSPFv3 Configuration Options (continued)
Command Syntax and Usage
timers spf <SPF delay (0‐65535)> <SPF hold time (0‐65535)>
Configures the number of seconds that SPF calculation is delayed after a
topology change message is received.
The default value is 5 seconds.
Configures the number of seconds between SPF calculations.
The default value is 10 seconds.
Command mode: Router OSPF3
no timers spf
Resets the SPF timers to their default values ‐ SPF delay to 5 seconds and SPF
hold time to 10 seconds.
Command mode: Router OSPF3
show ipv6 ospf
Displays the current OSPF configuration settings.
Command mode: All
The following table describes the OSPFv3 Area Index commands.
Table 275.
OSPFv3 Area Index Configuration Options
Command Syntax and Usage
area <0‐2> area­id <IP address>
Defines the IP address of the OSPFv3 area number.
Command mode: Router OSPF3
area <0‐2> default­metric <metric value (1‐16777215)>
Configures the cost for the default summary route in a stub area or NSSA.
Command mode: Router OSPF3
area <0‐2> default­metric type <1‐3>
Configures the default metric type applied to the route.
Note: This command applies only to area type of Stub/NSSA.
Command mode: Router OSPF3
no area <0‐2> default­metric
Resets the cost for the default summary route to its default value of 1.
Command mode: Router OSPF3
[no] area <0‐2> enable
Enables or disables the OSPF area.
Command mode: Router OSPF3
Chapter 4: Configuration Commands
497