Virtual Nic Group Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

Virtual NIC Group Configuration
602
G8264CS Command Reference for ENOS 8.4
Table 360.
vNIC Port Configuration Options
Command Syntax and Usage
bandwidth <1‐100>
Configures the maximum bandwidth allocated to this vNIC, in increments of
100 Mbps. For example:
1 = 100 Mbps

10 = 1000 Mbps

Command mode: vNIC configuration
[no] enable
Enables or disables the vNIC.
Command mode: vNIC configuration
The following table describes the Virtual NIC (vNIC) Group configuration options.
Table 361.
vNIC Group Configuration Options
Command Syntax and Usage
vnic vnicgroup <1‐32>
Enters vNIC Group Configuration mode.
Command mode: Global Configuration
[no] enable
Enables or disables the vNIC Group.
Command mode: vNIC Group configuration
[no] failover
Enables or disables uplink failover for the vNIC Group. Uplink Failover for the
vNIC Group will disable only the affected vNIC links on the port. Other port
functions continue to operate normally.
The default setting is disabled.
Command mode: vNIC Group configuration
[no] member <vNIC number>
Adds or removes a vNIC to the vNIC Group. The vNIC ID is comprised of the
port number and the vNIC number. For example: 1.1.
Command mode: vNIC Group configuration
[no] port <port number or alias>
Adds or removes the selected switch port to the vNIC Group.
Command mode: vNIC Group configuration