Lenovo RackSwitch G8264CS Cli Command Reference page 562

Protocol Independent Multicast Configuration
562
G8264CS Command Reference for ENOS 8.4
The following table describes the PIM commands.
Table 324.
PIM Configuration Options
Command Syntax and Usage
ip pim component <1‐2>
Enter PIM component mode.
Command mode: Global configuration
no ip pim component <2>
Deletes the PIM component.
Command mode: Global configuration
[no] ip pim enable
Globally enables or disables PIM.
Command mode: Global configuration
[no] ip pim pmbr enable
Enables or disables PIM border router.
The default setting is disabled.
Command mode: Global configuration
ip pim regstop­ratelimit­period <0‐2147483647>
Configures the register stop rate limit, in seconds.
The default value is 5 seconds.
Command mode: Global configuration
default ip pim regstop­ratelimit­period
Reset the register stop rate limit to its default value of 5 seconds.
Command mode: Global configuration
no ip pim regstop­ratelimit­period
Disables the register stop rate limit.
Command mode: Global configuration
[no] ip pim static­rp enable
Enables or disables static RP configuration.
The default setting is disabled.
Command mode: Global configuration