Lenovo RackSwitch G8264CS Cli Command Reference page 27

© Copyright Lenovo 2017
Table 3.
Description of Global Commands
Command
ping
Action
Use this command to verify station‐to‐station
connectivity across the network. The format is as
follows:
ping [{<hostname>|<IP address>} [<tries
(0‐4294967295)> [<msec‐delay (0‐4294967295)>
[<length (0/32‐65500/2080)> [<source IP address>
[<ttl (1‐255)> [<tos (0‐255)>
[dont­fragment]]]]]]][data­port|mgt­por
t]]
Where:
hostname/IP address: Sets the hostname or

IP address of the target station.
tries: Sets the number of attempts (optional).

msec­delay: Sets the number of milliseconds

between attempts (optional).
length: Sets the ping request payload size

(optional).
source IP address: Sets the IP source

address for the IP packet (optional).
ttl: Sets the Time to live in the IP header.

tos: Sets the Type of Service bits in the IP

header.
dont­fragment: Sets the don't fragment bit in

the IP header (only for IPv4 addresses).
By default, the management port is used. To use a
specific port, use the following options:
data port: data­port

management port: mgt­port

Note: The DNS parameters must be configured if
specifying hostnames.
27
Chapter 1: ISCLI Basics