Layer 3 Link Aggregation Group (LAG) Hash
440
G8264CS Command Reference for ENOS 8.4
Layer 3 Link Aggregation Group (LAG) hash parameters are set globally. You can
enable one or both parameters, to configure any of the following valid
combinations:
SIP (source IP only)
DIP (destination IP only)
SIP and DIP
Use the following commands to configure Layer 3 LAG hash parameters for the
switch.
Table 231.
Layer 3 LAG Hash Options
Command Syntax and Usage
portchannel thash l3thash l3destinationipaddress
Enables Layer 3 LAG hashing on the destination IP address.
Command mode: Global configuration
portchannel thash l3thash l3sourceipaddress
Enables Layer 3 LAG hashing on the source IP address.
Command mode: Global configuration
portchannel thash l3thash l3sourcedestinationip
Enables Layer 3 LAG hashing on both the source and the destination IP
address.
Command mode: Global configuration
portchannel thash l3thash l3usel2hash
Enables use of Layer 2 hash parameters only. When enabled, Layer 3 hashing
parameters are cleared.
Command mode: Global configuration
show portchannel hash
Displays the current LAG hash settings.
Command mode: All