System Host Log Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

System Host Log Configuration
© Copyright Lenovo 2017
The following table describes the System Host Log commands.
Table 144.
Host Log Configuration Options
Command Syntax and Usage
logging buffer severity <0‐7>
Sets the severity level of the syslog messages saved to flash memory.
The default is 7, which means log all severity levels.
Command mode: Global configuration
no logging buffer severity
Disables the saving of syslog messages to the flash memory.
Command mode: Global configuration
[no] logging console
Enables or disables delivering syslog messages to the console.
The default setting is enabled.
Note: When necessary, disabling console logging ensures the switch is not
affected by syslog messages.
Command mode: Global configuration
logging console severity <0‐7>
This option sets the severity level of syslog messages delivered via the console,
telnet, and SSH. The system displays only messages with the selected severity
level and above. For example, if you set the console severity to 2, only
messages with severity level of 1 and 2 are displayed.
The default is 7, which means log all severity levels.
Command mode: Global configuration
no logging console severity
Disables delivering syslog messages to the console based on severity.
Command mode: Global configuration
logging host <1‐2> address <IPv4 address>
Sets the IP address of the first or second syslog host.
Command mode: Global configuration
logging host <1‐2> address6 <IPv6 address>
Sets the IPv6 address of the first or second syslog host.
Command mode: Global configuration
logging host <1‐2> {data­port|mgt­port}
Sets the port of the first or second syslog host.
Command mode: Global configuration
Chapter 4: Configuration Commands
309