System User Id Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

System User ID Configuration
350
G8264CS Command Reference for ENOS 8.4
Table 162.
User Access Control Configuration Options
Command Syntax and Usage
access user user­password
Sets the user (user) password. The user has no direct responsibility for switch
management. The user view switch status information and statistics, but cannot
make any configuration changes.
This command will prompt for required information: current admin password,
new password (up to 64 characters) and confirmation of the new password.
Note: To disable the user account, set the password to null (no password).
Command Mode: Global configuration
show access user
Displays the current user status.
Command mode: Privileged EXEC
clear line <1‐12>
Ejects the user with the corresponding session ID from the G8264CS.
Command mode: Privileged EXEC
The following table describes the System User ID commands.
Table 163.
User ID Configuration Options
Command Syntax and Usage
[no] access user <1‐20> enable
Enables or disables the user ID.
Command mode: Global configuration
access user <1‐20> level {user|operator|administrator}
Sets the Class‐of‐Service to define the user's authority level. Lenovo N/OS
defines these levels as: User, Operator and Administrator, with User being the
most restricted level.
Command mode: Global configuration
access user <1‐20> name <1‐64 characters>
Defines the user name of maximum eight characters.
Command mode: Global configuration
access user <1‐20> password
Sets the user (user) password. This command will prompt for required
information: current admin password, new password (up to 64 characters) and
confirmation of the new password.
Command mode: Global configuration