Hot Links; Forward Delay; Preemption; Fdb Update - Lenovo ThinkSystem NE2552E Application Manual

Hot Links

Forward Delay

Preemption

FDB Update

434
NE2552E Application Guide for ENOS 8.4
Hot Links provides basic link redundancy with fast recovery.
Hot Links consists of up to 25 triggers. A trigger consists of a pair of layer 2
interfaces, each containing an individual port, LAG, or LACP adminkey. One
interface is the Master, and the other is a Backup. While the Master interface is set
to the active state and forwards traffic, the Backup interface is set to the standby
state and blocks traffic until the Master interface fails. If the Master interface fails,
the Backup interface is set to active and forwards traffic. Once the Master interface
is restored, it transitions to the standby state and blocks traffic until the Backup
interface fails.
You may select a physical port, static LAG, or an LACP adminkey as a Hot Link
interface. Only external uplink ports can be members of a Hot Links trigger
interface.
The Forward Delay timer allows Hot Links to monitor the Master and Backup
interfaces for link stability before selecting one interface to transition to the active
state. Before the transition occurs, the interface must maintain a stable link for the
duration of the Forward Delay interval.
For example, if you set the Forward delay timer to 10 seconds using the command:
NE2552E(config)# hotlinks trigger <x> forward-delay 10
the switch will select an interface to become active only if a link remained stable for
the duration of the Forward Delay period. If the link is unstable, the Forward Delay
period starts again.
You can configure the Master interface to resume the active state whenever it
becomes available. With Hot Links preemption enabled, the Master interface
transitions to the active state immediately upon recovery. The Backup interface
immediately transitions to the standby state. If Forward Delay is enabled, the
transition occurs when an interface has maintained link stability for the duration of
the Forward Delay period.
Use the FDB update option to notify other devices on the network about updates to
the Forwarding Database (FDB). When you enable FDB update, the switch sends
multicasts of addresses in the forwarding database (FDB) over the active interface,
so that other devices on the network can learn the new path. The Hot Links FBD
update option uses the station update rateto determine the rate at which to send
FDB packets.