Lenovo RackSwitch G8264CS Cli Command Reference page 559

Virtual Router Group Priority Tracking Configuration
© Copyright Lenovo 2017
Note: If Virtual Router Group Tracking is enabled, then the tracking option will be
available only under group option. The tracking setting for the other individual
virtual routers will be ignored.
Table 321.
Virtual Router Group Priority Tracking Configuration Options
Command Syntax and Usage
[no] group track interfaces
When enabled, the priority for this virtual router will be increased for each
other IP interface active on this switch. An IP interface is considered active
when there is at least one active port on the same VLAN. This helps elect the
virtual routers with the most available routes as the master.
This command is disabled by default.
Command mode: Router VRRP
[no] group track ports
When enabled, the priority for this virtual router will be increased for each
active port on the same VLAN. A port is considered "active" if it has a link and
is forwarding traffic. This helps elect the virtual routers with the most
available ports as the master.
This command is disabled by default.
Command mode: Router VRRP
show ip vrrp group track
Displays the current configuration for priority tracking for this virtual router.
Command mode: All
Chapter 4: Configuration Commands
559