Layer 3 Configuration - Lenovo RackSwitch G8264CS Cli Command Reference

Layer 3 Configuration

460
G8264CS Command Reference for ENOS 8.4
The following table describes basic Layer 3 Configuration commands. The
following sections provide more detailed information and commands
Table 249.
Layer 3 Configuration Commands
Command Syntax and Usage
interface ip <1‐128>
Configures the IP Interface. The G8264CS supports up to 128 IP interfaces. To
view command options, see page
Command mode: Global configuration
ip pim component <1‐2>
Enters Protocol Independent Multicast (PIM) component configuration mode.
To view command options, see page
Command mode: Global configuration
ip router­id <IP address>
Sets the router ID.
Command mode: Global configuration
no ip router­id
Removes the router ID.
Command mode: Global configuration
route­map <1‐64>
Enters IP Route Map mode. To view command options, see page
Command mode: Global configuration
router bgp
Enters Border Gateway Protocol (BGP) configuration mode. To view
command options, see page
Command mode: Global configuration
router ospf
Enters OSPF configuration mode. To view command options, see page
Command mode: Global configuration
ipv6 router ospf
Enters OSPFv3 configuration mode. To view command options, see page
Command mode: Global configuration
router rip
Enters the Routing Interface Protocol (RIP) configuration mode. To view
command options, see page
Command mode: Global configuration
462.
562.
512.
481.
.
476.
485.
495.