IGMP Static Multicast Router Configuration
532
G8264CS Command Reference for ENOS 8.4
The following table describes the commands used to configure a static multicast
router.
Note: When static Mrouters are used, the switch continues learning dynamic
Mrouters via IGMP snooping. However, dynamic Mrouters may not replace static
Mrouters. If a dynamic Mrouter has the same port and VLAN combination as a
static Mrouter, the dynamic Mrouter is not learned.
Table 298.
IGMP Static Multicast Router Configuration Options
Command Syntax and Usage
ip igmp mrouter port <port alias or number> <VLAN ID (1‐4094)>
<version (1‐3)>
Selects a port/VLAN combination on which the static multicast router is
connected, and configures the IGMP version of the multicast router.
Command mode: Global configuration
no ip igmp mrouter {port <port alias or number> <VLAN ID (1‐4094)>
<version (1‐3)>|all}
Removes all static multicast routers or a specific static multicast router from
the selected port/VLAN combination.
Command mode: Global configuration
clear ip igmp mrouter
Clears the dynamic multicast router port table.
Command mode: Privileged EXEC
show ip igmp mrouter
Displays the current IGMP Multicast Router parameters.
Command mode: All