Parameter
Filter x profile Indicates the ACL number.
Ethernet
IPv4
TCP/UDP
Meter
Re‐Mark
© Copyright Lenovo 2017
The following command displays Access Control List (ACL) information:
show accesscontrol list <1‐256>
Command mode: All
Current ACL List information:
Filter 1 profile:
Ethernet
SMAC : 00:00:aa:aa:01:fe/ff:ff:ff:ff:ff:ff
DMAC : 00:0d:60:9c:ec:d5/ff:ff:ff:ff:ff:ff
VID : 10/0xfff
Ethertype : IP (0x0800)
Priority : 3
Meter
Set to disabled
Set committed rate : 64
Set max burst size : 32
ReMark
Set use of TOS precedence to disabled
Packet Format
Ethernet format : None
Tagging format : Any
IP format : None
Actions : Deny
Statistics : enabled
Mirror Target Configuration:
Mirror target destination: port
Egress port for mirror target: 4
If the ACL is being used with Policy‐Based Routing (PBR), the output from this
command is more like the following:
Filter 1 profile: routemap 16
IPv4
Protocol : 17
Actions : Permit
: dscp 22
Statistics : enabled
Installed on Port 16
Access Control List (ACL) information includes configuration settings for each
ACL.
Table 65.
ACL List Parameter Descriptions
Description
Displays the ACL Ethernet header parameters, if configured.
Displays the ACL IPv4 header parameters, if configured.
Displays the ACL TCP/UDP header parameters, if configured.
Displays the ACL meter parameters.
Displays the ACL re‐mark parameters.
Chapter 2: Information Commands
145