Lenovo RackSwitch G8264CS Cli Command Reference page 230

230
G8264CS Command Reference for ENOS 8.4
Table 107.
Layer 3 Statistics Commands (continued)
Command Syntax and Usage
show ipv6 route counters
Displays IPv6 route statistics. See page
Command mode: All
show ip slp counters
Displays Service Location Protocol (SLP) statistics.
Command mode: All
show ip tcp counters
Displays Transmission Control Protocol (TCP) statistics. See page
sample output.
Command mode: All
show ip udp counters
Displays User Datagram Protocol (UDP) statistics. See page
output.
Command mode: All
show ip vrrp counters
When virtual routers are configured, you can display the protocol statistics for
Virtual Router Redundancy Protocol (VRRP). See page
Command mode: All
show layer3 counters
Dumps all Layer 3 statistics. Use this command to gather data for tuning and
debugging switch performance. If you want to capture dump data to a file, set
your communication software on your workstation to capture session data
prior to issuing the dump command.
Command mode: All
clear ip arp counters
Clears Address Resolution Protocol (ARP) statistics.
Command mode: Privileged EXEC
clear ip arp inspection statistics [vlan <VLAN ID (1‐4094)>]
Clears Dynamic ARP Inspection statistics.
Command mode: Privileged EXEC
clear ip counters
Clears IPv4 statistics. Use this command with caution as it deletes all the IPv4
statistics.
Command mode: Privileged EXEC
241 for sample output.
248 for sample
264 for sample output.
246 for