Lenovo RackSwitch G8264CS Cli Command Reference page 303

© Copyright Lenovo 2017
Table 141.
System Configuration Options (continued)
Command Syntax and Usage
system custom­dst
Configures Custom Daylight Saving Time settings. For command options, see
page 355.
Command mode: Global configuration
system date <yyyy> <mm> <dd>
Prompts the user for the system date. The date retains its value when the
switch is rebooted.
Command mode: Global configuration
[no] system daylight
Enables or disables daylight savings time in the system clock. When enabled,
the switch will add an extra hour to the system clock so that it is consistent
with the local clock.
By default, this option is disabled.
Command mode: Global configuration
[no] system dhcp [hostname|syslog]
Enables or disables Dynamic Host Control Protocol for setting the IP address
on interface 1. When enabled, the IP address obtained from the DHCP server
overrides the static IP address.
The default setting is enabled.
hostname enables or disables hostname option support

syslog enables or disables log server option support

Command mode: Global configuration
system idle <0‐60>
Sets the idle timeout for CLI sessions in minutes. A value of 0 disables the
system idle timeout.
The default value is 10 minutes.
Command mode: Global configuration
system linkscan {fast|normal|slow}
Configures the link scan interval used to poll the status of ports. The values for
the different intervals are:
fast ‐ 75 miliseconds

normal ‐ 150 miliseconds

slow ‐ 500 miliseconds

Command mode: Global configuration
Chapter 4: Configuration Commands
303