RP Candidate Configuration
RP Static Configuration
564
G8264CS Command Reference for ENOS 8.4
Use these commands to configure a PIM router Rendezvous Point (RP) candidate.
Table 326.
RP Candidate Configuration Options
Command Syntax and Usage
rpcandidate holdtime <0‐255>
Configures the hold time of the RP candidate, in seconds.
Command mode: PIM Component
no rpcandidate holdtime
Resets the hold time of the RP candidate to its default value of 0 seconds.
Command mode: PIM Component
[no] rpcandidate rpaddress <group multicast address>
<group subnet mask> <IP address>
Adds or removes an RP candidate.
Command mode: PIM Component
Use these commands to configure a static PIM router Rendezvous Point (RP).
Table 327.
RP Static Configuration Options
Command Syntax and Usage
rpstatic rpaddress <group multicast address> <group subnet mask>
<IP address>
Adds a static RP.
Command mode: PIM Component
no rpstatic rpaddress <group multicast address> <group subnet mask>
Removes the specified static RP.
Command mode: PIM Component