© Copyright Lenovo 2017
Table 216.
Multiple Spanning Tree Configuration Options (continued)
Command Syntax and Usage
spanningtree mst maxhops <4‐60>
Configures the maximum number of bridge hops a packet may traverse before
it is dropped.
The default value is 20 hops.
Command mode: Global configuration
instance <0‐32> vlan <VLAN ID (1‐4094)>
Map the specified VLANs to the Spanning Tree instance. If a VLAN does not
exist, it is not created automatically.
Note: This command becomes visible only when the spanning tree mode is
MSTP.
Command mode: MST configuration
no instance <0‐32> vlan {<VLAN ID (1‐4094)>|all}
Remove the specified VLANs or all VLANs from the Spanning Tree instance.
Command mode: MST configuration
name <1‐32 characters>
Configures a name for the MSTP region. All devices within an MSTP region
must have the same region name.
Command mode: MST configuration
no name
Clears the name of the MSTP region.
Command mode: MST configuration
revision <0‐65535>
Configures a revision number for the MSTP region. The revision is used as a
numerical identifier for the region. All devices within an MSTP region must
have the same revision number.
Command mode: MST configuration
no revision
Resets the revision number for the MSTP region.
Command mode: MST configuration
default spanningtree mst <0‐32>
Restores a Spanning Tree instance or range of instances to default
configuration.
Command mode: Global configuration
Chapter 4: Configuration Commands
419