Lenovo RackSwitch G8264CS Cli Command Reference page 581

FC Port Configuration
FC VLAN Configuration
© Copyright Lenovo 2017
Use the following commands to configure Fibre Channel ports.
Table 343.
Fibre Channel Port Configuration Commands
Command Syntax and Usage
interface fc <FC port alias or number>
Enter Fibre Channel port configuration mode.
Command mode: Global configuration
[no] shutdown
Disables or enables the FC port.
The default setting is enabled (no shutdown).
Command mode: FC Port configuration
fc­speed {4|8|auto}
Configures the Fibre Channel port speed in Gbps or allows the port to
negotiate its speed automatically.
The default setting is auto.
Command mode: FC Port configuration
[no] type e
Enable the FC port to type E or disable the E port.
Command mode: FC Port configuration
Use the following commands to configure the Fibre Channel Forwarding VLAN.
Table 344.
FCF VLAN Configuration Commands
Command Syntax and Usage
vlan <VLAN ID (1‐4094)>
Enter VLAN configuration mode.
Command mode: Global configuration
[no] fcf enable
Enables or disables the VLAN as Fibre Channel Forwarding VLAN.
The default setting is disabled.
Command mode: VLAN configuration
npv disruptive­load­balance
Triggers a disruptive load‐balance among the logged‐in nodes in the current
NPV VLAN.
Command mode: VLAN configuration
Chapter 4: Configuration Commands
581