Lenovo RackSwitch G8264CS Cli Command Reference page 437

Link Aggregation Group (LAG) Hash Configuration
© Copyright Lenovo 2017
Use the following commands to configure Link Aggregation Group (LAG) hash
settings for the G8264CS. The LAG hash settings affect both static LAGs and LACP
LAGs.
To achieve the most even traffic distribution, select options that exhibit a wide
range of values for your particular network. You may use the configuration
settings listed in Table 229 combined with the hash parameters listed in Table
and Table 231.
Table 229.
LAG Hash Options
Command Syntax and Usage
[no] portchannel thash fcoe cntag­id
Enables or disables FCoE LAG hashing on the cntag id.
Command mode: Global configuration
[no] portchannel thash fcoe destination­id
Enables or disables FCoE LAG hashing on the destination id.
Command mode: Global configuration
[no] portchannel thash fcoe fabric­id
Enables or disables FCoE LAG hashing on the fabric id.
Command mode: Global configuration
[no] portchannel thash fcoe originator­id
Enables or disables FCoE LAG hashing on the originator id.
Command mode: Global configuration
[no] portchannel thash fcoe responder­id
Enables or disables FCoE LAG hashing on the responder id.
Command mode: Global configuration
[no] portchannel thash fcoe source­id
Enables or disables FCoE LAG hashing on the source id.
Command mode: Global configuration
[no] portchannel thash ingress
Enables or disables LAG hash computation based on the ingress port.
The default setting is disabled.
Command mode: Global configuration
Chapter 4: Configuration Commands
230
437